M4 CCO ZERO TARGET PDF

M4 – 1 click=2 MOA. • When zeroing The recommended mounting position of the M68 CCO is the forward rail slot on . On a 25 meter M16A2 zeroing target. A Battle Sight Zero allows you to aim center mass on a target and achieve a hit from zero to meters. . M16A4. M4/M4A1. Carrying Handle. Windage. ½ MOA. 1 MOA. Carrying Handle. Elevation. 1 ½ MOA CCO (Windage and. Elevation). feedback (Figure 10). The M Sight, RCO, when installed on a M4/M4A1/ M16A4/M16A2, is zeroed on a standard M16 zero target with alternate strike points.

Author: Zolokinos Kigajind
Country: Saint Kitts and Nevis
Language: English (Spanish)
Genre: Software
Published (Last): 14 December 2010
Pages: 65
PDF File Size: 17.10 Mb
ePub File Size: 13.16 Mb
ISBN: 961-9-81563-523-5
Downloads: 31058
Price: Free* [*Free Regsitration Required]
Uploader: Gutaur

Place the firearm in a safe condition prior to handling or making any of the exercises demonstrated below. Aimpoint red dot sights are optically centered.

It is easiest if you start the zeroing process from a short distance. We recommend 25 meters.

This allows you to immediately see if further adjustments need to be made, which in turn can save you time and ammunition. This method uses Aimpoint shooting targets, which are available for free here. Place firearm in solid rest and center dot on the target.

  COLLIN MOSHMAN PDF

How to Zero Your Aimpoint Sight

This target shows that the point of impact was too much to the right and a little too low. With the information given on top of the printed Aimpoint shooting target, and by counting the number of squares between the actual point of impact and the desired point of impact on the target, you can quickly and precisely detemine how many clicks you need to move the adjustment screws in order to zero your sight see image “Target 2”.

Trget another shot to check that the point of impact is centered. If you still need to adjust slightly, repeat the procedure.

Step by Step Guide

Unscrew and remove the protective caps from the adjustment turrets to access the adjustment screws. That the information on the adjustment screws can vary from one sight model to garget. It shows either UP-R on both the elevation and the windage screws or UP on the elevation screw and R on the windage screw.

On the windage side to side, or horizontal adjustment screw, located on the side of the sight, you can see an arrow and UP-R. Turn in the opposite direction of the arrow if you want to move the point of impact to the left. On the elevation up and down, or vertical adjustment screw, located on the top of the sight, you can see an arrow UP-R. Turn in the opposite direction of the arrow if ,4 want to move the point of impact down.

  BANGLA SERA BHUTER GOLPO PDF

FM Chapter 8 Advanced Optics, Lasers, And Iron Sights (Phase V of

Step by Step Guide. Zeroing with Aimpoint Shooting Target.

Set up the target at 25 meters. How to Rotate the Adjustment Screws. Follow the direction of the arrow to move the point of impact to the right R.

Follow the direction of the arrow to move the point of impact up UP.