ASTM D4066 PDF

Buy ASTM D CLASSIFICATION SYSTEM FOR NYLON INJECTION AND EXTRUSION MATERIALS (PA) from SAI Global. ASTM D Standard Classification System for Nylon Injection and Extrusion Materials (PA). standard by ASTM International, 07/01/ View all product. 暂无评价|0人阅读|0次下载 | 举报文档. D – 01A Nylon Injection and Extrusion Materials_能源/化工_工程科技_专业资料。ASTM D标准.

Author: Fauzil Tujin
Country: Anguilla
Language: English (Spanish)
Genre: Politics
Published (Last): 11 February 2013
Pages: 255
PDF File Size: 14.91 Mb
ePub File Size: 2.11 Mb
ISBN: 837-9-98150-620-6
Downloads: 15052
Price: Free* [*Free Regsitration Required]
Uploader: Yozshuzil

D ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. After the humidity conditioning speci? Thus, a letter designation G for glass reinforced and 35 for percent or reinforcement, G35, speci?

Industrial & Engineering Plastics

This example is a general purpose, low viscosity nylon 6 material where U denotes? G Izod impact for these materials shall be conducted on specimens with a NOTE 8—Ash content of?

General Principles ISO The holes shall be drilled as above and then reamed, using a standard-tapered pin reamer, to a sufficient depth to allow the pins to extend approximately Breakdown by short-time test, kV Testing Conditions ISO There may be other requirements necessary to identify particular characteristics important to specialized applications. These may be specified by using the suffixes as given in Section 5.

  ACCELERATED OSTEOGENIC ORTHODONTICS PDF

Some of these compositions astk also suitable for compression molding and application from solution. Table PA is used astj specify the group of nylon and Table Atm or B is used to specify property requirements.

Originally published as D — Link to Active This link will always route to the current Active version of the standard. NOTE 10—When a grade of polyamide is not fully identi? Details of these methods will be included in a future revision of Speci?

Material selection should be made by those having expertise in the plastic? Nylon Processing and T It is possible that materials incorporating other pigments or soluble stabilizers, or both may prove adequate for particular applications. Relative viscosity of Group 08 shall be sstm on 9.

Requirements are based on unannealed test specimens 3. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Nylon 6 Supplier | Type 6/6 Nylon | Nylon Sheet

A specific hazards statement is given in Viscosities for Groups 03, 04, 06, and 08 are measured as described as follows. This section may also include descriptions of the changes or reasons for the changes, or both.

  DE SERVO ARBITRIO MARTIN LUTERO PDF

It aztm possible, by agreement between the buyer and the seller, that materials incorporating other pigments or soluble stabilizers, or both, may prove adequate for particular applications.

Last previous edition D — The report shall consist of results of the lotacceptance inspection for the shipment and the results of the most recent periodic-check inspection. D — 00a: NOTE 4—An example of this classi?

Material selection should be made by those having expertise in the plastic field after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those awtm by this classification system.

These specimens shall be tested. These are electrical limits applied to reinforced nylons when control of their electrical properties is required.

Tensile strength and elongation shall be determined on Test Method D test specimens 3.